Benjamin Adapters

  This design goes back to the barrel and slides over the barrel bushing. This will keep the barrel aligned with the adapter's exit hole. Please note that the barrel bushing is not included. Factory gun already includes the bushing. The .357 Benjamin Bulldog is becoming popular for big game hunting. Add this adapter and pair it up with a .357 Ronin or .357 Emperor to make it the ultimate hunting airgun. I would recommend going with minimum the .357 Ronin for this gun. The .357 FX suppressor is not enough to quiet this gun down. IF you use an Emperor with this gun, do not add the extender. Too much weight added applied to the adapter and may cause inaccuracies.  Made by CNC for accuracy Very easy to install. Remove the top and bottom screw securing the front cap and swap it out for this adapter. Screw the two screws back in and you're done. No need to remove the shroud. Matte Black anodize Knurled thread protector When putting this on, press the adapter into the shroud as you tighten the two screws. This will ensure the adapter is flush with the shroud.

  *Note: For the Akela, remove one of the factory baffles in order for the adapter to fit flush. Features:  Made by CNC for accuracy Material is 6061 T6 Aluminum Matte black anodize Diamond pattern knurling for easy grip Compatible with .177, .22 and .25 calibers

Features: This adapter has a 1/2 x 20 adapter at the end Has two holes on top like OEM so you can use original screws and front site. Overall length from one end to the other is 3.12 inches has groove underneath just like OEM for ease of removing fill cap CNC Matte Black Anodize Match this up with a .22 Tatsu and you have a nice quiet gun.

Want to make your Prod quieter? You'll need this 1/2 x 20 adapter, it will screw into the OEM shroud. The threads that screws into the shroud is 11/16 - 24.  The Sumo 1/2 x 20 is my favorite suppressor for this gun. However, in order to fill this gun with the Sumo, you'll have to remove the suppressor. An alternative is to go with either the Tanto or KOI with cone rear cap. Features:  Made by CNC for accuracy Material is 6061 T6 Aluminum Black anodize Diamond pattern knurling for easy grip

This adapter extends the shroud 1.5 inches or about 38.1mm. Pair it up with a .22-25 Tanto 1/2 x 20 Bolt #S69 and this pistol will be very quiet. No need to remove the suppressor to fill the gun. Features: 6061 Aluminum Black anodized Comes with knurled thread protector  

Marauders are great entry level PCP guns. There are lots of mods you can do to make them more powerful. More power means a louder gun. To make it backyard friendly, make sure to grab this adapter to allow you to screw on an aftermarket LDC. Threaded end that goes into the OEM shroud is 13/16 - 28. Features:    Made by CNC for accuracy Material is 6061 T6 Aluminum Black anodize Diamond pattern knurling for easy grip